Remove Descent Remove Runway Remove Wind Shear
article thumbnail

NTSB: Pilot Was Flying Too Low Before Hitting Smokestack in Idaho

Flying Magazine

The aircraft collided with an exhaust stack that lies directly beneath the extended centerline of Runway 20. Google Earth view of the Gem State Processing plant and Runway 20 at KBYI. The white dashed line is an estimate of the extended centerline of Runway 20. The accident happened shortly after 8:30 a.m.

Pilot 122
article thumbnail

B-1B bomber accident at Ellsworth AFB caused by crew errors, unhealthy culture

Aerotime

At approximately 17:47 local time, the B-1B supersonic bomber, tail number 85-0085, crash-landed outside Runway 13 at Ellsworth Air Force Base. The aircraft touched down about 100 feet (30 meters) short of the runway, causing the rear radome to strike the ground and the main landing gear to hit the approach lighting system.

Insiders

Sign Up for our Newsletter

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Trending Sources

article thumbnail

Invisible Trap Kills Glider Pilot – How To Avoid Microbursts

Chess In the Air

I was listening intently to the ASOS for wind or gusts, letting it repeat 5 or 6 times with the exact same report: 9 kts straight down the runway; no gusts. That was the runway we would use to land. It’s worth noting that Shmulik had a close call in the past: a jet pulled onto the runway in front of him with no radio call.

Pilot 52
article thumbnail

How to Perform a Go-Around (The Right Way)

Pilot Institute

These include a runway collision, porpoising, bouncing, or possible overrun. ATC can also ask for a go-around if the landing runway is unsafe or for spacing reasons. An approach is stabilized when: The aircraft is on the correct flight path, i.e., on runway centerline and glideslope. Airspeed is not less than 1.3Vso +10/-0.

article thumbnail

Sweet Dreams

Photographic Logbook

But a wall of haze ahead did not bode well for the arrival to Northeast Philadelphia and the airport ATIS (automatic terminal information service) indicated that arrivals were using the RNAV instrument approach procedure to runway 6. I pulled the power back and set a notch of flaps to establish a 90 knot, 500 foot/minute descent.

article thumbnail

How to Brief an Instrument Approach (Step-by-Step)

Pilot Institute

The heading contains the city, state, airport, runway, and approach name. The landing minimums section includes: Minimum descent altitudes. Preflight Planning Some pilots believe an approach briefing means skimming the chart right before descent. Are there runway closures? Plan view. Decision altitudes/heights.