Remove Descent Remove Knot Remove Wind Shear
article thumbnail

Invisible Trap Kills Glider Pilot – How To Avoid Microbursts

Chess In the Air

Moderate wind shear in some areas could make some thermals somewhat difficult to work but that, too, is typical. Between 5:10 and 5:34 PM, Rifle’s AWOS system reported light winds out of the west in the range of 4 to 9 kts (see chart below) with no wind gusts. Some passing high clouds were unlikely to be a factor.

Pilot 52
article thumbnail

How to Perform a Go-Around (The Right Way)

Pilot Institute

Weather Go-arounds due to weather occur due to wind shear caused by gusting winds or microbursts. When an aircraft encounters horizontal wind shear, it could be blown off centerline. Similarly, if an aircraft encounters vertical wind shear, it reduces or increases the sink rate.

article thumbnail

Sweet Dreams

Photographic Logbook

I pulled the power back and set a notch of flaps to establish a 90 knot, 500 foot/minute descent. As usual, the field AWOS (automated weather observation system) lied its nonexistent ass off with a declaration of five knot winds.