Airspeed Junkie

AUGUST 2, 2024

This system includes modes for: roll pitch heading vertical speed altitude hold approach These modes allow for a steady rate of descent, ascent, and consistent speed and altitude ranges. For instance, Knots 2U offers a Cessna 172 Cowl / Body Fairing Kit that improves aerodynamics and can increase cruise speed by 3-4 mph.

Knot 98

Knot Cockpit Pilot Gross Weight 98

Pilot Institute

JULY 12, 2024

Learn to use aircraft references to establish a stable descent rate and pitch, ending up in a smooth roundout and flare. The easiest way to achieve this is by flying a stabilized approach. So, what is a stabilized approach? Flying at 60 knots? 60 x 5 = 300 feet per minute is your recommended descent rate.

Descent 52

Descent Weight-Shift-Control Crosswind Runway 52

Plane and Pilot

AUGUST 3, 2024

However, if you take a close look at the inboard upper wing surface of the B-52, you will see a neat row of vortex generators that correspond to the width of the horizontal stabilizer. These were added to manage the low speed air flow over the wings, stabilizer and elevators.

Airplanes 86

Airplanes Approach Horizontal Stabilizer Pilot 86

Pilot Institute

OCTOBER 16, 2024

Descent Point Nominate a descent point that will give you a constant 3° profile to the threshold. This allows you to configure appropriately and ensures a stabilized approach. We can calculate the rate of descent required to achieve a 3° profile. Take your ground speed in knots and divide it by two.

Airplanes 52

Airplanes Descent Approach Final Approach 52

Pilot Institute

OCTOBER 13, 2024

Key Takeaways Bounced landings can result from excessive speed, improper flare, or high descent rates. Improper Flare Technique The flare is a maneuver where you elevate the aircraft’s nose slightly just before landing to decrease the descent rate. Use power as necessary to control the descent rate.

Descent 52

Descent Runway Rudder Pilot 52

Pilot Institute

MAY 4, 2024

In the Cessna 172S Pilot’s Operating Handbook (POH), the landing distance decreases by 10% for every 9 knots of headwind. For the Cessna 172, landing distance increases by 10% for every 2 knots of tailwind. Any substantial changes to speed and descent rate will destabilize the landing.

Weight-Shift-Control 52

Weight-Shift-Control Runway Approach Density Altitude 52

Vintage Aviation News

FEBRUARY 19, 2025

It was capable of flying up to 172 mph (277 km/h, 149 knots) and reach a service ceiling of 18,000 ft (5,500 m). The aircraft began its descent from an altitude of 1,000 feet to land on a predetermined spot at NASA Ames Research Center, December 7, 1962.

Thrust 72

Thrust Center of Gravity Descent Cockpit 72

Pilot's Life Blog

JUNE 21, 2024

Cessna has defined the ideal short-field landing speed at 61 knots. When flying different types of aircraft, particularly smaller aircraft, it’s worth considering a landing speed of three to five knots slower. The higher you raise your pitch, the slower your descent on the way down.

Stability 52

Stability Approach Knot Clearance 52

Pilot Institute

MARCH 26, 2024

As with any landing, it’s vital to have a stabilized approach. If you’re not stabilized at 200 feet AGL, go around. High-wing aircraft might need more power or pitch to arrest the descent. High Descent Rate If you have a high sink rate on approach, you’ll have a tough time arresting the descent during the roundout.

NOTAMs 52

NOTAMs Runway Approach Descent 52

Pilot Institute

MARCH 29, 2024

The stall warning horn sounds at least 5 knots above the actual stall speed. Since you need to fly without triggering the warning, select a target airspeed of about 2 to 5 knots more. Trim for level flight once you’re stabilized at your target speed. Turbulent air will require a larger airspeed margin.

Lift 52

Lift Rudder Drag Checkride 52

Flight Training Central

MAY 1, 2024

Also check on the school’s financial stability and refund policy in the event you must withdraw for whatever reason and always be cautious of paying large sums of money up front. maximum weight and 120 knots maximum speed (a Cessna Skycatcher, for example). Since most people take longer, you could end up spending considerably more.

Pilot in Command 98

Pilot in Command Pilot Airplanes Air Traffic Control 98

Pilot Institute

FEBRUARY 20, 2025

What Is Aircraft Stability? Stability is the aircrafts tendency to maintain its attitude or orientation. This means that they have to be effective enough to counter the aircrafts inherent lateral stability. Lateral stability depends on the aircrafts design. What Materials Are Used in Ailerons?

Aileron 90

Aileron Weight-Shift-Control Rudder Longitudinal Axis 90

Plane and Pilot

SEPTEMBER 20, 2024

Alongside a nearby highway, some recognizable bits of airplane, the vertical stabilizer and rudder, a horizontal stabilizer and elevator, fell separately to Earth. But a review of the avionics data shows it was entered at the correct airspeed (placarded as between 104 and 165 knots), and the roll rate was constant.

True Airspeed 95

True Airspeed Indicated Airspeed Horizontal Stabilizer Aileron 95

Plane and Pilot

SEPTEMBER 20, 2024

Alongside a nearby highway, some recognizable bits of airplane, the vertical stabilizer and rudder, a horizontal stabilizer and elevator, fell separately to Earth. But a review of the avionics data shows it was entered at the correct airspeed (placarded as between 104 and 165 knots), and the roll rate was constant.

True Airspeed 94

True Airspeed Indicated Airspeed Horizontal Stabilizer Aileron 94

Pilot Institute

JUNE 26, 2024

Top Reasons for Go-Arounds Unstabilized Approach An aircraft must have a stabilized approach before landing. An approach is stabilized when: The aircraft is on the correct flight path, i.e., on runway centerline and glideslope. The aircraft was 44 knots higher than its target landing speed, which resulted in a runway overrun.

Wind Shear 52

Wind Shear Runway Approach Aeronautical Decision-Making 52

Pilot Institute

FEBRUARY 15, 2025

Horizontal wind speeds near the surface can be as fast as 45 knots, resulting in a 90-knot wind shear from headwind to tailwind across the microburst. In seconds, an aircraft can be forced into an uncontrollable descent, leaving you with barely any time to react. Formation of Microbursts Where does it all start?

Wind Shear 66

Wind Shear Weather Descent Approach 66

Plane and Pilot

OCTOBER 3, 2024

We routinely taxi at 1200 rpm due to the low spray…[we] can cruise at 10 knots” in displacement mode, something a Goose can’t do. Early on a speed restriction of 130 knots was applied as a flutter issue. This was resolved on the kit version and led to cruising at 50% power and 120 knots, which proved to be the Gweduck’s sweet spot.

Airplanes 80

Airplanes Rudder Knot Aileron 80

AV Web

APRIL 15, 2025

Fixed-Wing Foibles Consider the Airbus first officer (FO) who tried to satisfy ATCs request to increase their descent (rate), so he engaged open descent mode. The captain took control and applied aft stick pressure to return the airplane to a normal descent pitch attitude to prevent an overspeed. Other than that, what?

Pilot 52

Pilot Airplanes Runway Descent 52

Plane and Pilot

NOVEMBER 13, 2024

/hp Engine: Rotax 912iSC3, 4-cylinder, opposed, air and liquid cooled, normally aspirated, gear-reduction drive, fuel-injected, 100 hp Propeller: MT composite, two-blade, constant-speed Maximum Cruise Speed: 117 knots Range, Max Range Power: 950 nm Rate of Climb, Sea Level: 750 fpm Max operating Altitude: 13,000 ft. Takeoff Over 50-ft.

Knot 98

Knot Rudder Airplanes Gross Weight 98

Pilot's Life Blog

JANUARY 5, 2025

Approach speeds typically range from 80 to 90 knots depending on weight and flap settings, while full flaps are often used to provide the necessary lift during landing. The pre-landing check is the first step in ensuring the aircraft is ready for a stable descent. Additionally, configure the aircraft for a stable descent.

Descent 52

Descent Final Approach Approach Runway 52