Remove Crosswind Remove Knot Remove Wind Shear
article thumbnail

How to Read a Windsock

Pilot Institute

The wide end of a windsock points into the wind, while the narrow end indicates its direction. Standard FAA aviation windsocks are calibrated to fully extend at a wind speed of 15 knots. Regular inspection of windsocks makes sure you receive reliable wind information. Extended halfway: Winds are around 7-8 knots.

Knot 98
article thumbnail

A Touristy Timeout for Safety

Plane and Pilot

Dawn had broken bright and clear, and while icing , ceiling, and visibility had been my preoccupationrightfully so, given our arrival into Portlandthe actual threat of the day was wind. As we walked from the wharf to breakfast, I saw that peak wind gusts were tickling the 40-knot mark.

Insiders

Sign Up for our Newsletter

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Trending Sources

article thumbnail

Step-by-Step Guide: How to Land a Piper Seminole Safely

Pilot's Life Blog

Approach speeds typically range from 80 to 90 knots depending on weight and flap settings, while full flaps are often used to provide the necessary lift during landing. Review current weather conditions, including wind speed, direction, and visibility, as these can significantly impact the approach.

Descent 52
article thumbnail

When Training Turns Too Realistic

Plane and Pilot

No flying in winds exceeding 10 knots, no chance of obscuring precipitation, no use of runways shorter than 5,000 feet, no risk of encountering darkness or lowering ceilings. is a common question, when the wind, ceiling, visibility, turbulence, or even temperature are obviously not conducive to routine flying. 1 priority.

Runway 52
article thumbnail

When Training Turns Too Realistic

Plane and Pilot

No flying in winds exceeding 10 knots, no chance of obscuring precipitation, no use of runways shorter than 5,000 feet, no risk of encountering darkness or lowering ceilings. is a common question, when the wind, ceiling, visibility, turbulence, or even temperature are obviously not conducive to routine flying. 1 priority.

Runway 52
article thumbnail

How to Perform a Go-Around (The Right Way)

Pilot Institute

Weather Go-arounds due to weather occur due to wind shear caused by gusting winds or microbursts. When an aircraft encounters horizontal wind shear, it could be blown off centerline. Similarly, if an aircraft encounters vertical wind shear, it reduces or increases the sink rate.