article thumbnail

Randy’s Warbird Profiles: Goodyear F2G-1 Super Corsair BuNo. 88454

Vintage Aviation News

Hamilton propeller (9-inch clearance from prop tip to ground or carrier deck) and was generally armed with six.50cal. The large propeller on Corsairs caused a lot of torque at slow speeds which caused the port wing to drop at stalling speeds and creating a tendency for the aircraft to go into a spin. machine guns, eight 5in.

Torque 98
article thumbnail

Under the Knife

Plane and Pilot

still applies after surgery, of course, but the FAA will have less to object to at renewal time if it receives a half-inch stack of papers covering diagnosis, ailment progression, surgical report, physical therapy (PT) report, and surgeon clearance. If you time it right, you can hand in the sheaf of papers at the FAA building at Oshkosh.

Torque 76
Insiders

Sign Up for our Newsletter

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Trending Sources

article thumbnail

A Crowded House for the Widow of Reading

Photographic Logbook

The chirping we heard was due to excess torque-related motion of the powerplant in the engine compartment. Ray later found that the nuts securing the remaining three mounts were insufficiently torqued by whomever mounted that engine before the Williamson Flying Club bought the airplane in 2021. Dan received the same clearance.

Torque 52
article thumbnail

Icing, Systems, and Human Factors: Preliminary Findings on Voepass flight 2283

Fear of Landing

The crew acknowledged and said that they were at the ideal point of descent and waiting for clearance. The approach controller instructed the crew to continue to wait for the descent clearance. When they called a second time, the approach controller asked them to maintain FL170 (17,000 feet) to remain clear of other traffic.

Knot 98
article thumbnail

Nothing Small About It

Plane and Pilot

Another advantage of the counter-rotating props is the elimination of torque roll. This is the tendency to dig in the left tip float during takeoff while countering engine torque. These are natural suggestions for an airplane moving from prototype to kit, and the folks at Composite Creations have it at the top of their list.