CFI Academy

MARCH 28, 2025

Heres what they are and what you need to understand about each: Crossed-Control Stall What It Is: This stall occurs when the aircraft is in a skidding turn, typically with ailerons applied in one direction and rudder in the opposite direction (e.g., left aileron, right rudder). How to Perform: Enter a turn (e.g.,

Aileron 96

Aileron Rudder Checkride AGL 96

Northstar VFR

MARCH 30, 2025

Make sure you're at the recommended altitude (600-1,000 feet AGL) per ACS guidelines. Maintain 600-1,000 feet AGL. Maintain 600-1,000 feet AGL. Use rudder appropriately to prevent slipping or skidding through turns. Final Thoughts Ground reference maneuvers may seem basic, but theyre foundational for precise flying.

Groundspeed 52

Groundspeed AGL Crosswind Rudder 52

Pilot Institute

NOVEMBER 2, 2024

On final approach, it can be the difference between recovering and crashing. The ACS states that recovery should be completed no lower than 1,500 ft AGL for single-engine aircraft and 3,000 ft AGL for multi-engine aircraft. If the aircraft stalls and you are surprised, you might not be able to recover in time.

Descent 52

Descent Approach AGL Lift 52

Flight Training Central

DECEMBER 4, 2023

The final approach speed for a soft field approach and landing should be the same as is used for a short field technique to minimuze float once you enter ground effect. If gusty conditions are present, increase final approach airspeed by one half the gust factor.

Approach 52

Approach Ground Effect Final Approach Airplanes 52

Chess In the Air

JUNE 24, 2022

He only needed a glide ratio of 14:1 to reach the airfield to arrive at a typical pattern altitude of 1,000 ft AGL. At this point he still had an altitude of 8,275 ft MSL, i.e. 2,739 ft AGL. At this point he was just NW of the runway at an altitude of 8000 ft MSL (2464 AGL). After all, a pattern entry altitude of approx.

Pilot 52

Pilot AGL Wind Shear Runway 52