Remove AGL Remove Drag Remove Stability
article thumbnail

How to Make a Perfect Soft Field Landing Every Time

Pilot Institute

However, the increased drag might make it impossible to take off again. As with any landing, it’s vital to have a stabilized approach. If you’re not stabilized at 200 feet AGL, go around. On a normal landing, you’d pull the power over the threshold, begin your roundout, and flare around 10 feet AGL.

NOTAMs 52
article thumbnail

Mastering Short Field Landings (A Step-by-Step Guide)

Pilot Institute

x V SO (or POH recommendation) by around 500 feet AGL. This gives you a safe buffer on the stall speed and plenty of time to stabilize. Full flaps are generally used since they lower approach speed and increase drag. The drag allows for a steeper descent, which is particularly helpful when avoiding obstacles.

Insiders

Sign Up for our Newsletter

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Trending Sources

article thumbnail

How to Master Slow Flight (Step-By-Step)

Pilot Institute

Drag : The aerodynamic force opposing the aircraft’s forward motion. This increases lift but comes at the cost of increased induced drag. Pilots must counteract the additional drag with more thrust to maintain altitude. Fly at least 1,500 above ground level (AGL) to allow room for recovery in case you stall the aircraft.

Lift 52
article thumbnail

How to Perform a Go-Around (The Right Way)

Pilot Institute

Top Reasons for Go-Arounds Unstabilized Approach An aircraft must have a stabilized approach before landing. An approach is stabilized when: The aircraft is on the correct flight path, i.e., on runway centerline and glideslope. If the crew had gone around, they could’ve returned for a safer, stabilized approach and landing.