Remove AGL Remove Density Altitude Remove Wind Shear
article thumbnail

Invisible Trap Kills Glider Pilot – How To Avoid Microbursts

Chess In the Air

Moderate wind shear in some areas could make some thermals somewhat difficult to work but that, too, is typical. He only needed a glide ratio of 14:1 to reach the airfield to arrive at a typical pattern altitude of 1,000 ft AGL. At this point he still had an altitude of 8,275 ft MSL, i.e. 2,739 ft AGL.

Pilot 52
article thumbnail

Are Dry Microbursts Really An Invisible Trap? – Responding to Reactions

Chess In the Air

Considering the delay in the AWOS reporting, it may also be helpful to proactively use the radio to ask anyone on the ground for the current winds (e.g. Microbursts are not the only source of severe wind-shear close to the ground. Sudden and very powerful surface winds can have various other causes. the local FBO).

article thumbnail

How to Perform a Go-Around (The Right Way)

Pilot Institute

Weather Go-arounds due to weather occur due to wind shear caused by gusting winds or microbursts. When an aircraft encounters horizontal wind shear, it could be blown off centerline. Similarly, if an aircraft encounters vertical wind shear, it reduces or increases the sink rate.